Vacuum pump PW.7.14.1.1010.1 without motor, frame and coupling
Brand:
Hydro-VacuumCharacteristics
Producer:
Hydro Vacuum
Housing material:
Сast iron
Impeller material:
bronze
Rate of turn, rpm:
1 000
Power capacity, kW:
45
Pump capacity, cu.m/hour:
1500
Explosion protection:
No
See all
Categories
Favorite
Compare
Products from the same category
Also buy with this product
Exchange or returnWe will return or exchange for another product
Fast shippingWe will pick up and send promptly
Warranty and qualityGuaranteed return of goods within 10 days
On-line payment on the sitePayment is made by bank cards
Features Vacuum pump PW.7.14.1.1010.1 without motor, frame and coupling
Producer | Hydro Vacuum |
Housing material | Сast iron |
Impeller material | bronze |
Rate of turn, rpm | 1 000 |
Power capacity, kW | 45 |
Pump capacity, cu.m/hour | 1500 |
Explosion protection | No |
Seal | С-одинарное сальниковое уплотнение |
Max.flow rate, m3/h | 1500 |
Shaft material | AISI 420 |
Vacuum depth, mBar | 213 |
Material | cast iron |
Serial number of the pump | PW |
Country of Origin | Poland |
PumpType | vacuum |
Drive Type | electric |
Installation Type | horizontal |
Type of configuration | without engine |
Weight, kg | 570 |
Description Vacuum pump PW.7.14.1.1010.1 without motor, frame and coupling
Water ring vacuum pumps of the PW.7.14 series are single-stage vacuum pumps. They are designed for suction and pumping of dry gas with a temperature of up to 150°С and gases saturated with vapors, distinguished by the fact that their temperature does not exceed 100°С, with the possibility of using working fluids with a viscosity of up to 60 mm 2 / sec and a density of 800 - 1200 kg / m3, the water temperature at the pump outlet should not exceed 80°С. In pumps of the PW series, the pump and motor are mounted on a common support. Torque from the engine is transmitted to the impeller through a shaft installed in support bearings and an elastic coupling. This design makes the vacuum pump significantly longer and heavier, but due to this, it significantly facilitates its maintenance when disassembling the pump or replacing the motor is required. In addition, the pump is installed on 2 supports (impeller between bearings), which gives a longer service life.
Vacuum pump PW.7.14.1.1010.1 without motor, frame and coupling reviews
Help in selection
+38 067 360-71-01
Selection of mechanical seals
+38 095 656-37-57
Pump selection
If you have any questions when placing an order, or need help choosing a product, please contact the specified contacts.